2012

Grid Sets the snap to Grid. When you specify points, the cursor snaps along
vertical or horizontal grid points.
SOLID
Quick Reference
See also:
■ Modify Hatch Properties
Creates solid-filled triangles and quadrilaterals.
Summary
2D solids are filled only when the FILLMODE system variable is on (1) and
the viewing direction is orthogonal to the 2D solid.
List of Prompts
The following prompts are displayed.
First point Sets the first point in the 2D solid.
Second point Sets the first edge of the 2D solid.
Third point Sets the corner that is opposite the second point.
Fourth point or <exit> The fourth point is diagonally opposite the first point.
Pressing Enter at the Fourth Point prompt creates a filled triangle. Specifying
a fifth point creates a quadrilateral area.
Specifying successive third and fourth points creates further connected triangles
and four-sided polygons in a single solid object.
1160 | Chapter 19 S Commands