2012

Toolbar: Refedit
Summary
The objects that you select from the selected xref or block are temporarily
extracted and made available for editing in the current drawing. The set of
extracted objects is called the working set, which can be modified and then
saved back to update the xref or block definition.
List of Prompts
The following prompts are displayed.
Select reference: Select an xref or a block in the current drawing
If you edit an xref when the ribbon is active, the Edit Reference ribbon
contextual tab displays.
If you enter -refedit at the Command prompt,
options are displayed.
Edit Reference Ribbon Contextual Tab
Quick Reference
See also:
■ Edit Selected Objects in Referenced Drawings and Blocks
Manages the working set of objects that are edited in a reference.
Reference Editing Panel
Save or Discard Changes (
REFCLOSE on page 1071) Saves back or discards
changes made during in-place editing of a reference, either an xref or a block
definition.
Add to or Remove From Working Set (
REFSET on page 1077) Adds or removes
objects from a working set during in-place editing of a reference, either an
xref or a block definition.
Edit Reference Ribbon Contextual Tab | 1073