2012

Boundary Width
Specifies the maximum length of the lines of text in a multiple-line attribute
before wrapping to the next line. A value of 0.000 means that there is no
restriction on the length of a line of text.
Not available for single-line attributes.
Align Below Previous Attribute Definition
Places the attribute tag directly below the previously defined attribute. If you
have not previously created an attribute definition, this option is not available.
-ATTDEF
Quick Reference
See also:
■ Define Block Attributes
List of Prompts
The following prompts are displayed.
Current
attribute modes: Invisible=current Constant=current Verify=current
Preset=current Lock position=current Annotative =current Multiple line =current
Enter an option to change [Invisible/Constant/Verify/Preset/Lock
position/Annotative/Multiple lines] <done>:
Enter
attribute tag name: Enter any characters except spaces or exclamation points
Enter
attribute value: Enter the appropriate text or press ENTER (this prompt is
displayed only if you turned on Constant mode)
Enter attribute prompt: Enter the text for the prompt line or press ENTER (this
prompt is not displayed if you turned on Constant mode)
Enter default attribute value: Enter the appropriate text or press ENTER (this prompt
is not displayed if you turned on Constant mode)
Specify location of multiline attribute: Specify a point (this prompt is displayed
only if you turned on Multiple line mode)
Specify opposite corner: Specify a point or enter an option (this prompt is displayed
only if you turned on Multiple line mode)
Attribute Modes
The current value line indicates the current settings for each attribute mode
(either Y for on or N for off). Entering i, c, v, p, l, a, or m toggles the modes
on or off. Press ENTER when you have finished adjusting the mode settings.
-ATTDEF | 71