2012

List of Options
The following options are displayed.
Mode
Sets options for attribute values associated with a block when you insert the
block in a drawing.
The default values are stored in the
AFLAGS on page 1380 system variable.
Changing the AFLAGS setting affects the default mode for new attribute
definitions and does not affect existing attribute definitions.
Invisible
Specifies that attribute values are not displayed or printed when you insert
the block.
ATTDISP on page 74 overrides Invisible mode.
Constant
Gives attributes a fixed value for block insertions.
Verify
Prompts you to verify that the attribute value is correct when you insert the
block.
Preset
Sets the attribute to its default value when you insert a block containing a
preset attribute.
68 | Chapter 2 A Commands