2012

Specifying the value 32, 64, or 96 selects a shape to draw around the point,
in addition to the figure drawn through it:
PDSIZE controls the size of the point figures, except for PDMODE values 0
and 1. A setting of 0 generates the point at 5 percent of the drawing area
height. A positive PDSIZE value specifies an absolute size for the point figures.
A negative value is interpreted as a percentage of the viewport size.
After you change PDMODE and PDSIZE, the appearance of existing points
changes the next time the drawing is regenerated.
You can use MEASURE and DIVIDE to create points along an object. Use
DDPTYPE to specify point size and styles easily.
List of Prompts
Specify a point: Specify a point in the drawing
1010 | Chapter 16 P Commands