2012

Automatically calculates the X and Y offset values to center the plot on the
paper. This option is not available when Plot Area is set to Layout.
X
Specifies the plot origin in the X direction relative to the setting of the Plot
Offset Definition option.
Y
Specifies the plot origin in the Y direction relative to the setting of the Plot
Offset Definition option.
Plot Scale
Controls the relative size of drawing units to plotted units. The default scale
setting is 1:1 when plotting a layout. The default setting is Fit to Paper when
plotting from the Model tab.
Fit to Paper
Scales the plot to fit within the selected paper size and displays the custom
scale factor in the Scale, Inch =, and Units boxes.
Scale
Defines the exact scale for the plot. Custom defines a user-defined scale. You
can create a custom scale by entering the number of inches (or millimeters)
equal to the number of drawing units.
NOTE You can modify the list of scales with SCALELISTEDIT.
Inch(es) =/mm =/Pixel(s) =
Specifies the number of inches, millimeters, or pixels equal to the specified
number of units.
Inch/mm/pixel
Specifies inches or mm for display of units in the Plot dialog box. The default
is based on the paper size and changes each time a new paper size is selected.
Pixel is available only when a raster output is selected.
Units
Specifies the number of units equal to the specified number of inches,
millimeters, or pixels.
Scale Lineweights
966 | Chapter 16 P Commands