2011

Table Of Contents
NOTE The VP Transparency column is only available when a layout tab is
active.
3 In the Layer Transparency dialog box, click the drop-down list to select
a transparency level, or enter a value between 0 and 90 .
4 Click OK.
TIP To set the same trasparency level for multiple selected layers, press CTRL and
click to select more than one layer. Then click the Transparency or the VP
Transparency column to display the Layer Transparency dialog box.
To turn the Always Show option on or off in the LayerWalk dialog box
1 Click Home tab Layers panel Layer Walk.
2 In the LayerWalk dialog box, Layer list, double-click the layer you want
to set to Always Show. To select more than one layer, press SHIFT and
double-click the additional layers.
An asterisk (*) is displayed to the left of each layer that you set to Always
Show. These layers are displayed in the drawing regardless of whether or
not they are in an active filter.
3 Click Close.
To display selected layers while turning off all other layers
1 Click Home tab Layers panel Isolate.
2 Select an object on the layer you want to isolate.
3 Press Enter.
The selected layer is isolated.
NOTE To restore layers to the layer state before you isolated them, use the
LAYUNISO command. Any layer settings you changed are preserved.
316 | Chapter 14 Control the Properties of Objects