2011

Password Protected Underlay Files
If a file you want to attach as an underlay is password protected, you are
prompted to enter the password after you have selected the file. You cannot
attach the file until you have correctly entered the password.
After an underlay is attached to a DWG file, you are prompted for the underlay
file’s password each time you open the DWG file. If the DWG file is also
password protected, or has several other protected drawing references attached,
you may be prompted for multiple passwords.
If you change the path of an underlay to a file that requires a password, you
are prompted for a password as well.
NOTE DWF, DWFx, and PDF file passwords are case sensitive but DWG file
passwords are not. To make synchronization between DWG and DWF file passwords
easier, make sure the DWF, DWFx, and PDF file passwords match the DWG file
password and are entirely uppercase.
To attach a DWF or DWFx underlay
1 Click Insert tab ➤ Reference panel ➤ Attach.
2 In the Select Reference File dialog box, select the file you want to attach.
3 Click Open.
4 In the Attach DWF Underlay dialog box, select one sheet, or use SHIFT
or CTRL to select multiple sheets.
5 Use one of the following methods to specify the insertion point, scale,
or rotation of the underlay file:
■ Select Specify On-Screen to use the pointing device to attach the DWF
underlay at the location, scale, or angle you want.
■ Clear Specify On-Screen and enter values under Insertion Point, Scale,
or Rotation.
6 Click OK.
To attach a PDF underlay
1 Click Insert tab ➤ Reference panel ➤ Attach.
2 In the Select Reference File dialog box, select the PDF file you want to
attach.
3 Click Open.
Attach, Scale, and Detach Underlays | 1247