2013

If the surface is parallel to the construction plane with surface normals facing
in the same direction as the current UCS, the draft angle is 90.0. When
perpendicular, it is 0. If the surface is parallel to the current UCS with surface
normals facing in the opposite direction than the current UCS, the draft
angle is -90.0.
To change the draft analysis display settings, use the
Draft Angle tab (page
66) of the
Analysis Options dialog box (page 64).
See also:
Use the Draft Analysis Tool
ANALYSISOPTIONS
Sets the display options for zebra, curvature, and draft analysis.
Access Methods
Button
Toolbar: Modeling tool set  Analysis tool group  Surface Analysis
flyout  Analysis Options
Summary
The
Analysis Options dialog box (page 64) is displayed.
See also:
Analyze Surfaces
A Commands | 63