2013

Table Of Contents

List of Prompts

The following prompts are displayed.

Select objects: Use an object selection method and press Enter when you

finish

Specify base point: Specify a point

The base point you specify identifies the point that remains in the same

location as the selected objects change size (and thus move away from the

stationary base point).

NOTE When you use the SCALE command with annotative objects, the position

or location of the object is scaled relative to the base point of the scale operation,

but the size of the object is not changed.

Specify

scale factor (page 929) or [Copy (page 929)/Reference

(page 929)]: Specify a scale, enter c, or enter r

Scale Factor Multiplies the dimensions of the selected objects by the specified

scale. A scale factor greater than 1 enlarges the objects. A scale factor between

0 and 1 shrinks the objects. You can also drag the cursor to make the object

larger or smaller.

Copy Creates a copy of the selected objects for scaling.

Reference Scales the selected objects based on a reference length and a specified

new length.