2013

ALIGN Using Three Pairs of Points When you select three point pairs, you
can move and rotate the selected objects in 3D to align with other objects.
The selected objects move from the source point (1) to the destination point
(2).
The selected object is rotated (1 and 3) so that it aligns with the destination
object (2 and 4).
The selected object is then rotated again (3 and 5) so that it aligns with the
destination object (4 and 6).
See also:
Align Objects
AMECONVERT
Converts AME solid models to AutoCAD solid objects.
Summary
The objects you select must be Advanced Modeling Extension (AME) Release
2 or 2.1 regions or solids. All other objects are ignored.
Because of increased accuracy in the new solid modeler, AME models may
look slightly different after conversion. This difference is noticeable where
the previous version of the solid modeler identified the surfaces of two different
shapes as so close as to be considered in the same plane. The new solid
60 | Chapter 2 Commands