2013

List of Prompts
The following prompts are displayed.
Select objects: Select the objects to align and press Enter
Specify either one (page 59), two (page 59), or three pairs (page 60) of source
points and definition points to align the selected objects.
ALIGN Using One Pair of Points When you select only one source point and
destination point pair, the selected objects move in 2D or 3D from the source
point (1) to the destination point (2).
ALIGN Using Two Pairs of Points When you select two point pairs, you can
move, rotate, and scale the selected objects in 2D or 3D to align with other
objects.
The first set of source and destination points defines the base point for the
alignment (1, 2). The second set of points defines the angle of rotation (3, 4).
After you enter the second set of points, you are prompted to scale the object.
The distance between the first and second destination points (2, 4) is used as
the reference length to which the object is scaled. Scaling is available only
when you are aligning objects using two point pairs.
NOTE If you use two source and destination points to perform a 3D alignment
on non-perpendicular working planes, you get unpredictable results.
A Commands | 59