2013

Lock Objects Not in Working Set
Locks all objects not in the working set. This prevents you from accidentally
selecting and editing objects in the host drawing while in a reference editing
state.
The behavior of locked objects is similar to objects on a locked layer. If you
try to edit locked objects, they are filtered from the selection set.
See also:
Edit Selected Objects in Referenced Drawings and Blocks
-REFEDIT
Edits an xref or a block definition directly within the current drawing.
List of Prompts
The following prompts are displayed.
Select reference: Select an xref or block in the current drawing
Select nesting level [OK/Next] <Next>: Enter an option or press Enter
OK
Accepts the currently highlighted reference for in-place reference editing.
If you are editing a block reference with attributes, you can enter y to display
the attribute definitions and make them available for editing. The attributes
are made invisible, and the attribute definitions are available for editing along
with the selected reference geometry. When changes are saved back to the
block reference, the attributes of the original reference remain unchanged.
The new or altered attribute definitions affect only subsequent insertions of
the block; the attributes in existing block instances are not affected.
All Objects in the selected reference will be automatically included in the
reference editing session.
Nested After you close the Reference Edit dialog box and enter the reference
edit state, you are prompted to select the specific objects in the reference that
you want to edit.
Next
Advances through the reference and nested references available for selection.
The currently selected reference is highlighted.
R Commands | 887