2013

List of Prompts
The following prompts are displayed.
Current settings: Rotation = 0
Specify first corner point (page 879) or [Chamfer (page
879)/
Elevation (page 879)/Fillet (page 879)/Thickness (page
880)/
Width (page 880)]: Specify a point or enter an option
First Corner Point
Specifies a corner point of the rectangle.
Other Corner Point Creates a rectangle using the specified points as diagonally
opposite corners.
Area Creates a rectangle using the area and either a length or a width. If the
Chamfer or Fillet option is active, the area includes the effect of the chamfers
or fillets on the corners of the rectangle.
Dimensions Creates a rectangle using length and width values.
Rotation Creates a rectangle at a specified rotation angle.
Chamfer
Sets the chamfer distances for the rectangle.
Elevation
Specifies the elevation of the rectangle.
Fillet
Specifies the fillet radius of the rectangle.
R Commands | 879