2013

Summary
By default, a pyramid is defined by the center of the base point, a point on
the middle of the edge, and another point that determines the height.
Initially, the default base radius is not set to any value. During a drawing
session, the default value for the base radius is always the previously entered
base radius value for any solid primitive.
Use the Top Radius option to create a pyramid frustum.
List of Prompts
The following prompts are displayed.
Edge Specifies the length of one edge of the base of the pyramid; you pick
two points.
Specify first endpoint of edge: Specify a point
Specify second endpoint of edge: Specify a point
Sides Specifies the number of sides for the pyramid. You can enter a number
from 3 to 32.
Specify number of sides <default>: Specify a diameter or press Enter to specify
the default value
Initially, the number of sides for the pyramid is set to 4. During a drawing
session, the default value for the number of sides is always the previously
entered value for the number of sides.
Inscribed Specifies that the base of the pyramid is inscribed within (drawn
within) the base radius of the pyramid.
Circumscribed Specifies that the pyramid is circumscribed around (drawn
around) the base radius of the pyramid.
P Commands | 863