2013

Specify the next point (page 836) or [Arc (page 837)/Undo (page
838)]: Specify the next point for the profile of the solid, or enter an option
Object
Specifies an object to convert to a solid. You can convert:
 Line
 Arc
 2D polyline
 Circle
Select object: Select an object to convert to a solid
Height
Specifies the height of the solid. The default height is set to the current
PSOLHEIGHT (page 1450) setting.
Specify height <default>: Specify a value for the height, or press Enter to specify
the default value
The specified height value will update the
PSOLHEIGHT (page 1450) setting.
Width
Specifies the width of the solid. The default width is set to the current
PSOL-
WIDTH
(page 1451) setting.
Specify width <current>: Specify a value for the width by entering a value or
specifying two points, or press Enter to specify the current width value
The specified width value will update the
PSOLWIDTH (page 1451) setting.
Justify
Sets the width and height as the solid to be left, right, or center justified when
defining the profile with the command. The justification is based on the
starting direction of the first segment of the profile.
Enter justification [Left/Center/Right] <Center>: Enter an option for the
justification or press Enter to specify center justification
Next Point
Specify the next point or [Arc/Close/Undo]: Specify the next point for the profile
of the solid, enter an option, or press Enter to end the command
Arc Adds an arc segment to the solid. The default starting direction of the arc
is tangent to the last drawn segment. You can specify a different starting
direction with the Direction option.
836 | Chapter 2 Commands