2013

Location Determines the location of the plot stamp on the page based on
offset, orientation, and relationship to either the printable area or the border
of the paper.
Location selections include and are relative to the printable area or the border
of the paper, depending on what you specify at the prompt.
Enter stamp location [TL/TR/BL/BR] <BL>:
 TL: Top Left
 TR: Top Right
 BL: Bottom Left
 BR: Bottom Right
Text orientation indicates the rotation angle of the plot stamp in relation to
the page.
Enter text orientation [Horizontal/Vertical] <Horizontal>:
 Horizontal: Plot stamp will be horizontal relative to the page.
 Vertical: Plot stamp will be vertical relative to the page.
Stamp upside-down [Yes/No] <No>:
Specify plot stamp offset <0.1000,0.1000>:
Specifying an offset relative to the paper border calculates the offset values
that you specify from the corner of the paper. Specifying an offset relative to
the printable area calculates the offset values that you specify from the corner
of the printable area.
Specify offset relative to [paper Border/printable Area] <printable Area>:
Text Properties Determines the font name and text height for the current
plot stamp text. You can also specify to place the text on one line or to wrap
the text to two lines. The placement and offset values you specify for this plot
stamp must accommodate the text wrapping and the text height.
Enter font name <>: Enter a font name
Enter text height <0.1500>: Enter a value
Place plot stamp on single line? [Yes/No] <No >:
Units Specifies the units used to measure X offset, Y offset, and height. You
can define units using inches, millimeters, or pixels.
Enter measurement units [Inches/Millimeters/Pixels] <Inches>:
See also:
Set Options for Plotted Objects
818 | Chapter 2 Commands