2013

Landscape Orients and plots the drawing so that the long edge of the paper
represents the top of the page.
Plot upside down [Yes/No] <No>:
Orients and plots the drawing upside down.
Enter plot area [Display/Extents/Limits/Layout/View/Window] <current>:
Display Plots the view in the current viewport on the Model layout or the
current view in the layout, depending on which tab you select to plot.
Extents Plots all of the objects in the current viewport, except objects on
frozen layers. From a layout, plots all the geometry in paper space. The drawing
may be regenerated to recalculate the extents before plotting.
If you plot the drawing's extents with a perspective view active and the camera
position is within the drawing extents, this option has the same effect as the
Display option.
Limits Plots the drawing area defined by the grid limits. Available only when
the Model tab is selected.
Layout Plots everything within the printable area of the specified paper size,
with the origin calculated from 0,0 in the layout. Available only when a layout
tab is selected.
View Plots a view saved previously with the
VIEW (page 1139) command. You
can select a named view from the list provided. If there are no saved views in
the drawing, this option is unavailable.
Window Plots any portion of the drawing you specify. This option prompts
you to specify the corners of the window.
Enter lower left corner of window: Specify a point
Enter upper right corner of window: Specify a point
Enter plot scale (Plotted Inches = Drawing Units) or [Fit] <current>: Specify the
scale of the plot
Plotted Inches = Drawing Units Calculates the plot scale based on the inches
or millimeters to drawing units that you specify. You can also enter a real
number as a fraction (for example, you can enter 1=2 or .5).
Fit Calculates the scale to fit the area on the sheet of paper.
The default scale setting is 1:1 when you are plotting a layout, unless you
modified and saved the setting. The default setting is Fit when plotting a
Model tab.
P Commands | 809