2013

Detailed plot configuration [Yes (page 808)/No (page 808)]
<No>: Enter yor n or press Enter
No
Indicates that you do not want a detailed plot configuration for this plot.
Enter a layout name or [?] <current>:
Enter a page setup name < >:
Enter an output device name or [?] <current>:
Write the plot to a file [Yes/No] <current>:
Enter file name: <dwgname-layoutname.plt>:
Save changes to layout [Yes/No] <No>:
Proceed with Plot [Yes/No] <Y>:
For information about these prompts, see the description for Yes.
Yes
Specifies detailed page settings for the Model layout or layout you are plotting.
Enter a layout name or [?] <current>: Specify the name of the layout tab you want
to plot
Enter an output device name or [?] <current>: Specify the name of the output
device to which you want to plot the Model tab or layout tab you selected
If you enter a new device name without an extension, the program assumes
that the device is a PC3 file (Autodesk
®
HDI plotter configuration file). If no
PC3 file is found, the program searches for a Windows system printer with
that device name.
Enter paper size or [?] <current>: Specify the paper size to use for the plot or enter
? to view the actual list of paper sizes defined for the plotter driver
You must specify a paper size exactly as it is defined by the plotter driver.
Enter paper units [Inches/Millimeters] <current>:
The Enter Paper Units prompt is not displayed if you are plotting a raster
image, such as a BMP or TIFF file, because the size of the plot is assumed to
be in pixels.
Enter drawing orientation [Portrait/Landscape] <current>:
Portrait Orients and plots the drawing so that the short edge of the paper
represents the top of the page.
808 | Chapter 2 Commands