2013

List of Prompts
The following prompts are displayed.
Specify start point: Specify a point
Current line-width is <current>
Specify next point (page 798) or [Arc (page 798)/Close (page
801)/
Halfwidth (page 802)/Length (page 802)/Undo (page 802)/Width
(page 802)]: Specify a point or enter an option
Next Point
Draws a line segment. The previous prompt is repeated.
Arc
Adds arc segments to the polyline.
Specify endpoint of arc or
[Angle/CEnter/CLose/Direction/Halfwidth/Line/Radius/Second
pt/Undo/Width]: Specify a point (2) or enter an option
NOTE For the Center option of the PLINE command, enter ce; for the Center
object snap, enter cen or center.
Endpoint of Arc
Draws an arc segment. The arc segment is tangent to the previous segment of
the polyline. The previous prompt is repeated.
Angle
Specifies the included angle of the arc segment from the start point.
Specify included angle:
Entering a positive number creates counterclockwise arc segments. Entering
a negative number creates clockwise arc segments.
798 | Chapter 2 Commands