2013

Desmooth
Restores the original control-point polygon mesh.
Mclose
Closes the M-direction polylines if the polygon mesh is open in the M direction.
Mopen
Opens the M-direction polylines if the polygon mesh is closed in the M
direction.
Nclose
Closes the N-direction polylines if the polygon mesh is open in the N direction.
Nopen
Opens the N-direction polylines if the polygon mesh is closed in the N
direction.
Undo
Reverses operations as far back as the beginning of the PEDIT session.
PFACE
Creates a 3D polyface mesh vertex by vertex.
792 | Chapter 2 Commands