2013

Decurve
Removes extra vertices inserted by a fit or spline curve and straightens all
segments of the polyline. Retains tangent information assigned to the polyline
vertices for use in subsequent fit curve requests. If you edit a spline-fit polyline
with a command such as
BREAK (page 159) or TRIM (page 1101), you cannot use
the Decurve option.
Reverse
Reverses the order of vertices of the polyline. Use this option to reverse the
direction of objects that use linetypes with included text. For example,
depending on the direction in which a polyline was created, the text in the
linetype might be displayed upside down.
Undo
Reverses operations as far back as the beginning of the PEDIT session.
3D Polygon Mesh Selection (PEDIT)
If you select a polygon mesh, the following prompt is displayed:
List of Prompts
The following prompts are displayed.
Enter an option [Edit vertex/Smooth
surface/Desmooth/Mclose/Nclose/Undo]: Enter an option or press Enter
to end the command
Mclose and Nclose are replaced by Mopen and Nopen if the polygon mesh is
currently closed in the M or N direction.
Edit Vertex
Edits individual vertices of a polygon mesh that can be seen as a rectangular
M by N array, where M and N are the dimensions specified in
3DMESH (page
35). The
SURFTAB1 (page 1500) and SURFTAB2 (page 1500) system variables store
790 | Chapter 2 Commands