2013

Select page(s)
Displays all of the pages that are found in the PDF file. If the PDF file only
contains a single page, that page is listed. You can select multiple pages by
holding Shift or Cmd and selecting the pages to attach.
Show\Hide Attachment Options
Expands or collapses the Attachment Options section to allow you to specify
the insertion point, rotation and scale for the PDF underlay being attached.
Insertion Point
Specifies the insertion point for the selected PDF file.
Specify On-Screen Directs input at the Command prompt or the pointing
device.
X Sets the X coordinate value.
Y Sets the Y coordinate value.
Z Sets the Z coordinate value.
Rotation
Specifies the rotation angle of the selected PDF underlay.
Specify on-screen If Specify On-Screen is selected, you may wait until you
exit the dialog box to rotate the object with your pointing device or enter a
rotation angle value at the Command prompt.
Angle If Specify On-Screen is cleared, enter the rotation angle value in the
dialog box. The default rotation angle is 0.
Path Type
Select the full (absolute) path, the relative path to the PDF file, or No Path,
and the name of the PDF file. For the No Path option, the PDF file must be
located in the same folder as the current drawing file.
Scale
Specifies the scale factor of the selected PDF underlay.
If
INSUNITS (page 1373) is set to “unitless” or if the underlay does not contain
resolution information, the scale factor becomes the underlay width in
AutoCAD units. If INSUNITS has a value such as millimeters, centimeters,
inches, or feet, and the underlay has resolution information, the scale factor
is applied after the true width of the underlay in AutoCAD units is determined.
Specify On-screen Inputs information at the Command prompt or with the
pointing device. If Specify On-Screen is cleared, enter a value for the scale
factor.
Scale Factor Field Enter a value for the scale factor.
774 | Chapter 2 Commands