2013

-3DOSNAP
Uses command prompts to set running object snap modes for 3D objects.
List of Prompts
The following prompts are displayed.
Enter List of Object Snap Modes Specify one or more object snap modes by
entering the first four characters of the name. If you enter more than one,
separate the names with commas.
 ZVERtex. Snaps to a vertex or a control vertex.
 ZMIDpoint. Snaps to the midpoint on a face edge.
 ZCENter. Snaps to the center of a face.
 ZKNOt. Snaps to a spline knot.
 ZPERpendicular. Snaps to a perpendicular face (planar faces only).
 ZNEAr. Snaps to an object nearest to face.
 ZNONe. Turns off all 3D object snaps.
See the 3D Object Snaps tab of the
Drafting Settings dialog box (page 369) for
more information.
3DPAN
When a drawing is in a Perspective view, starts the interactive 3D view and
enables you to drag the view horizontally and vertically.
Access Methods
Menu: View  Pan  Realtime
Shortcut menu: Start any 3D navigation command, right-click in the drawing
area, and click Other Navigation Modes  Pan (9).
Toolbar: Status bar  Pan
Summary
Moves in the direction that you drag. You can drag the view vertically,
horizontally, or diagonally. 3DPAN changes the cursor to a hand cursor.
3D Commands | 45