2013

Table Of Contents

Offset Distance

Creates an object at a specified distance from an existing object.

Exit Exits the OFFSET command.

Multiple Enters the Multiple offset mode, which repeats the offset operation

using the current offset distance.

Undo Reverses the previous offset.

Through

Creates an object passing through a specified point.

NOTE For best results when you offset a polyline with corners, specify the through

point near the midpoint of a line segment, not near a corner.

 Exit (page 720)

 Multiple (page 720)

 Undo (page 720)

Erase

Erases the source object after it is offset.

Layer

Determines whether offset objects are created on the current layer or on the

layer of the source object.