2013

On the Model layout, you set the units type, drawing scale factor, and paper
size at the Command prompt using MVSETUP. Using the settings you provide,
a rectangular border is drawn at the grid limits.
List of Prompts
When the
TILEMODE (page 1511) system variable is on (the default), the
following prompt are displayed:
Enable paper space? [No/Yes] <Y>: Enternor press Enter
Pressing Enter turns off TILEMODE and proceeds as described in the following
section, Using MVSETUP on a Layout Tab. (page 707)
Entering n displays the following prompt:
Enter units type
[Scientific/Decimal/Engineering/Architectural/Metric]: Enter
an option
A list of available units and prompts for the scale factor and paper size are
displayed.
Enter the scale factor: Enter a value
Enter the paper width: Enter a value
Enter the paper height: Enter a value
A bounding box is drawn and the command ends.
See also:
Create and Modify Layout Viewports
MVSETUP on a Named Layout
On a named layout, you can insert one of several predefined title blocks into
the drawing and create a set of layout viewports within the title block.
You can specify a global scale as the ratio between the scale of the title block
in the layout and the drawing on the Model layout.
To easily specify all layout page settings and prepare your drawing for plotting,
you can also use the Page Setup Manager.
M Commands | 707