2013

Table Of Contents

NOTE Releases of AutoCAD earlier than AutoCAD 2000 do not support diagonal

fractions. If a multiline text object contains diagonal fractions, the fractions are

converted to horizontal fractions when you save the drawing to pre-AutoCAD

2000 releases. Diagonal fractions are restored when the drawing is re-opened in

AutoCAD 2000 or a later release. If a single multiline text object contains both

horizontal and diagonal fractions, all fractions are converted to diagonal fractions

when the drawing is reopened in AutoCAD 2000 or a later release.

Tolerance Stacks the selected text with the first number on top of the second

number. There is no line between the numbers.

Decimal A variation of the Tolerance style that aligns the decimal point of

both the upper and lower numbers of selected text.

Position

Specifies how fractions are aligned. Center alignment is the default. All stacked

text in an object uses the same alignment.

Top Aligns the top of the fraction with the top of the text line.

Center Centers the fraction vertically at the center of the text line.

Bottom Aligns the bottom of the fraction with the text baseline.

Text Size

Controls the size of the stacked text as a percentage of the size of the current

text style (from 25 to 125 percent).

Defaults

Saves the new settings as defaults or restores the previous default values to

the current stacked text.

AutoStack Button

Displays the

AutoStack Properties dialog box (page 693). AutoStack only stacks

numeric characters immediately before and after the carat, slash, and pound

characters. To stack nonnumeric characters, or text that includes spaces, select

the text and choose Stack from the text editor shortcut menu.