2013

Undo Undoes the last vertex point on the multiline.
Close Closes the multiline by joining the last segments with the first segments.
Justification
Determines how the multiline is drawn between the points you specify.
 Top (page 672)
 Zero (page 672)
 Bottom (page 672)
Top Draws the multiline below the cursor, so that the line with the most
positive offset is at the specified points.
Zero Draws the multiline with its origin centered at the cursor, so that the
element with an offset of 0.0 is at the specified points.
Bottom Draws the multiline above the cursor, so that the line with the most
negative offset is at the specified points.
672 | Chapter 2 Commands