2013

Leader Landing First
Specifies a location for the landing line of the multileader object.
Specify Leader Arrowhead Location Sets placement of the arrowhead for
the new multileader object.
If you exit the command at this point, then no text is associated with the
multileader line.
Content First
Specifies a location for the text or block associated with the multileader object.
Point Selection Sets placement for the text box for the text label associated
with the multileader object. When you finish entering your text, click OK or
click outside the text box.
If you choose End at this point, then no landing line is associated with the
multileader object.
Options
Specifies options for placing the multileader object.
Leader Type Specifies a straight, spline, or no leader line.
 Straight.
 Spline.
 None.
Leader Landing Changes the distance of the horizontal landing line
 Yes.
 No.
If you choose No at this point, then no landing line is associated with the
multileader object.
Content Type Specifies the type of content that will be used for the
multileader.

Block (page 656)

Mtext (page 657)

None (page 657)
Block Specifies a block within your drawing to associate with the new
multileader.
 Enter block name.
656 | Chapter 2 Commands