2013

Corner Sets the scale factor by using the block insertion point and the opposite
corner.

Specify Rotation Angle (page 647)

Number of Rows/Columns (page 647)

Distance Between Rows (page 647)

Distance Between Columns (page 647)
XYZ Sets X, Y, and Z scale factors.

X Scale Factor (page 647)

Corner (page 648)

Specify Rotation Angle (page 647)

Number of Rows/Columns (page 647)

Distance Between Rows (page 647)

Distance Between Columns (page 647)
Basepoint
Temporarily drops the block in the drawing where it is currently positioned
and allows you to specify a new base point for the block reference as it is
dragged into position. This does not affect the actual base point defined for
the block reference.
Scale
Sets the scale factor for the X, Y, and Z axes. The scale for the Z axis is the
absolute value of the specified scale factor.
 XYZ (page 648)
 Specify Rotation Angle (page 647)
 Number of Rows/Columns (page 647)
 Distance Between Rows (page 647)
 Distance Between Columns (page 647)
X
Sets the X scale factor.

Specify Rotation Angle (page 647)
 Number of Rows/Columns (page 647)
 Distance Between Rows (page 647)
 Distance Between Columns (page 647)
648 | Chapter 2 Commands