2013

Height of extrusion Extrudes mesh faces along the Z axis. Enter a positive
value to extrude the face along the positive Z axis. Enter a negative value to
extrude along the negative Z axis. Multiple mesh faces do not need to be
parallel to the same plane.
Direction Specifies the length and direction of the extrusion. (The direction
cannot be parallel to the plane of the sweep curve created by the extrusion.)
 Start point of direction. Specifies the first point in the direction vector.
 End point of direction. Specifies the second point in the direction
vector.
Path Specifies an object, such as a line or spline, that determines the path and
length of the extrusion. The outline of the mesh face is swept along the path.
The new orientation of the swept mesh face is perpendicular to the endpoint
of the path.
The path should not lie on the same plane as the mesh face or have areas of
high curvature. For extrusions that adhere closely to the curved path, use a
spline, not an arced polyline, as the path.
Taper angle Sets an angle of taper for an extrusion.
M Commands | 637