2013

Table Of Contents

You can also apply creases to mesh subobjects by changing the crease type

and crease level in the

Properties Inspector palette (page 844).

List of Prompts

The following prompts are displayed.

Select mesh subobjects to crease Specifies the mesh subobjects to crease.

Click mesh faces, edges, and vertices to crease their associated edges. Press

Shift+click to remove a subobject from the selection set.



Crease value (page 635)



Always (page 635)

Crease value Sets highest smoothing level at which the crease is retained. If

the smoothing level exceeds this value, the crease is also smoothed.

Enter a value of 0 to remove an existing crease.

Always Specifies that the crease is always retained, even if the object or

subobject is smoothed or refined. A crease value of -1 is the same as Always.