2013

 Length (page 630)
Cube Sets all edges of the mesh wedge base to be of equal length.

Length (page 630)
Length Sets the length of the mesh wedge base along the X axis.

Width (page 630) (not available for Cube)
Width Sets the width of the mesh box along the Y axis.

Height (page 630)

2Point (height) (page 630)
Height Sets the height of the mesh wedge. Enter a positive value to draw the
height along the positive Z axis of the current UCS. Enter a negative value to
draw the height along the negative Z axis.
2Point (height) Defines the height of the mesh wedge by specifying the
distance between two points:
 First point. Sets the first point of a two-point distance.
 Second point. Sets the second point of a two-point distance.
Torus
Creates a 3D mesh primitive torus.
Specify two values: the size of the tube and the distance from the center of
the torus to the center of the tube.
Center point Sets the center point of the mesh torus.

Radius (torus) (page 631)

Diameter (torus) (page 632)
630 | Chapter 2 Commands