2013

Ttr (tangent, tangent, radius) Defines a mesh sphere with a specified radius
that is tangent to two objects:
 Point on object for first tangent. Sets a point on an object to serve
as the first tangent point.
 Point on object for second tangent. Sets a point on an object to serve
as the second tangent point.
 Radius of circle. Sets the radius of the mesh sphere.
If the specified criteria can produce multiple results, the closest tangent points
are used.
Wedge
Creates a 3D mesh wedge.
Specify the length and width of the base and the height.
First corner Sets the first corner of the mesh wedge base.
 Other corner. Sets the opposite corner of the mesh wedge base, located
on the X,Y plane.

Height (page 630)

2Point (height) (page 630)

Cube (page 630)

Length (page 630)
Center Sets the center point of the mesh wedge base.
 Corner. Sets one corner of the mesh wedge base.
Height (page 630)

2Point (height) (page 630)

Cube (page 630)
M Commands | 629