2013

 2Point (height) (page 627)

Axis endpoint (page 627)
Circumscribed Specifies that the base of the pyramid is circumscribed, or is
drawn around, the base radius.

Base radius (page 627)

Inscribed (page 627)
Sphere
Creates a 3D mesh sphere.
Specify the size of the sphere (diameter or radius).
Center point Sets the center point of the sphere.
 Radius. Creates a mesh sphere based on a specified radius.
 Diameter. Creates a mesh sphere based on a specified diameter.
3P (three points) Sets the location, size, and plane of the mesh sphere by
specifying three points:
 First point. Sets the first point on the circumference of the mesh sphere.
 Second point. Sets a second point on the circumference of the mesh
sphere.
 Third point. Sets the size and planar rotation of the mesh sphere.
2P (diameter) Sets the diameter of the mesh sphere by specifying two points:
 First endpoint of diameter. Sets the first point on the diameter of the
mesh sphere.
 Second endpoint of diameter. Sets the opposite point on the diameter
of the mesh sphere.
628 | Chapter 2 Commands