2013

Specify the diameter and height.
Center point of base Sets the center point of the base of the mesh cone.

Base radius (page 623)

Diameter (page 623)
3P (three points) Sets the location, size, and plane of the mesh cone by
specifying three points:
 First point. Sets the first point on the circumference of the mesh cone
base.
 Second point. Sets a second point on the circumference of the mesh
cone base.
 Third point. Sets the size and planar rotation of the mesh cone base.
Height (page 623)

2Point (height) (page 623)

Axis endpoint (page 624)

Top radius (page 624)
2P (diameter) Defines the base diameter of the mesh cone based on two
points:
 First endpoint of diameter. Sets the first location on the circumference
of the mesh cone base.
 Second endpoint of diameter. Determines the general location and
size of the mesh cone base by setting the endpoint of the diameter.

Height (page 623)

2Point (height) (page 623)

Axis endpoint (page 624)

Top radius (page 624)
Ttr (tangent, tangent, radius) Defines the base of the mesh cone with a
specified radius that is tangent to two objects:
 Point on object for first tangent. Sets a point on an object to serve
as the first tangent point.
 Point on object for second tangent. Sets a point on an object to serve
as the second tangent point.
 Radius of circle. Sets the radius of the mesh cone base.
Height (page 623)
622 | Chapter 2 Commands