2013

Start Angle
Specifies the draft angle for the start cross section. (
LOFTANG1 (page 1395)
system variable)
Start Magnitude
Controls the relative distance of the surface from the start cross section in the
direction of the draft angle before the surface starts to bend toward the next
cross section. (
LOFTMAG1 (page 1396) system variable)
End Angle
Specifies the draft angle for the end cross section. (LOFTANG2 (page 1396) system
variable)
End Magnitude
Controls the relative distance of the surface from the end cross section in the
direction of the draft angle before the surface starts to bend toward the previous
cross section. (
LOFTMAG2 (page 1396) system variable)
Close Surface or Solid
Closes and opens a surface or solid. When using this option, the cross sections
should form a torus-shaped pattern so that the lofted surface or solid can form
a closed tube. (
LOFTPARAM (page 1397) system variable)
594 | Chapter 2 Commands