2013

Start Continuity
Sets the tangency and curvature of the first cross section.
Start Bulge Magnitude
Sets the size of the curve of the first cross section.
End Continuity
Sets the tangency and curvature of the last cross section.
End Bulge Magnitude
Sets the size of the curve of the last cross section.
Normal To
Controls the surface normal of the solid or surface where it passes through
the cross sections. (
LOFTNORMALS (page 1397) system variable)
Start Cross Section Specifies that the surface normal is normal to the start
cross section.
End Cross Section Specifies that the surface normal is normal to the end cross
section.
Start and End Cross Sections Specifies that the surface normal is normal to
both the start and end cross sections.
All Cross Sections Specifies that the surface normal is normal to all cross
sections.
Draft Angles
Controls the draft angle and magnitude of the first and last cross sections of
the lofted solid or surface. The draft angle is the beginning direction of the
592 | Chapter 2 Commands