2013

Objects That Can Be
Used as Guides
Objects That Can Be
Used as a Loft Path
Objects That Can Be
Used as Cross Sections
Region
Trace
To automatically delete the cross sections, guides, and paths, use
DELOBJ
(page 1251). If surface associativity (page 1498) is on, DELOBJ is ignored and the
originating geometry is not deleted.
List of Prompts
The following prompts are displayed.
Cross Sections in Lofting Order Specifies open or closed curves in the order
in which the surface or solid will pass through them.
Point If you select the Point option, you must also select a closed curve.
Join Multiple Curves Joins multiple, end-to-end curves as one cross section.
Mode Controls whether the lofted object is a solid or a surface.
Options

Guides (page 589)

Path (page 589)

Cross sections only (page 590)

Settings (page 590)
Continuity This option only displays if the
LOFTNORMALS (page 1397) system
variable is set to 1 (smooth fit). Specifies whether the continuity is G0, G1, or
G2 where the surfaces meet.
588 | Chapter 2 Commands