2013

Y
Sets the Y scale factor.
Z
Sets the Z scale factor.
Uniform Scale
Specifies a single scale value for X, Y, and Z coordinates.
Rotation
Specifies the rotation angle for the inserted block in the current UCS.
Specify On-Screen
Specifies the rotation of the block using the pointing device.
Angle
Sets a rotation angle for the inserted block.
Block Unit
Displays information about the block units.
Unit
Specifies the
INSUNITS (page 1373) value for the inserted block.
Factor
Displays the unit scale factor, which is calculated based on the
INSUNITS
(page 1373) value of the block and the drawing units.
See also:
Insert Blocks
-INSERT
Inserts a block or drawing into the current drawing.
List of Prompts
The following prompts are displayed.
I Commands | 525