2013

If INSUNITS (page 1373) is set to “unitless” or if the image does not contain
resolution information, the scale factor becomes the image width in AutoCAD
units. If INSUNITS has a value such as millimeters, centimeters, inches, or
feet, and the image has resolution information, the scale factor is applied after
the true width of the image in AutoCAD units is determined.
Specify On-Screen Allows you to input at the Command prompt or the
pointing device. If Specify On-Screen is cleared, enter a value for the scale
factor. The default scale factor is 1.
Scale Factor Field Enter a value for the scale factor. The default scale factor
is 1.
Rotation
Specifies the rotation angle of the selected image.
Specify On-Screen If Specify On-Screen is selected, you may wait until you
exit the dialog box to rotate the object with your pointing device or enter a
rotation angle value at the Command prompt.
Angle If Specify On-Screen is cleared, enter the rotation angle value in the
dialog box. The default rotation angle is 0.
Path Type
Select the full (absolute) path, the relative path to the image file, or No Path,
the name of the image file (the image file must be located in the same folder
as the current drawing file).
Details
Displays details about the selected image file.
Resolution Displays the number of horizontal and vertical pixels per the
current unit measurement in AutoCAD.
Unit Displays the current AutoCAD unit.
Image Size in Pixels Displays the width and height of the raster image
measured in pixels.
Image Size in Units Displays the width and height of the raster image
measured in AutoCAD units.
Path
 Found In. Displays the path where the image file is located.
 Saved Path. Displays the path that is saved with the drawing when the
image file is attached. The path is dependent upon the Path Type setting.
516 | Chapter 2 Commands