2013

-HATCHEDIT
Uses command prompts to modify hatch-specific properties, such as pattern,
scale, and angle for existing hatches or fills.
List of Prompts
The following prompts are displayed.
Select hatch objects:
Enter hatch option [
DIsassociate (page 499)/Style (page
499)/
Properties (page 499)/DRaw order (page 499)/ADd boundaries
(page 500)/Remove boundaries (page 500)/recreate Boundary (page
500)/
ASsociate (page 500)/separate Hatches (page 500)/Origin
(page 500)/ANnotative (page 501)/hatch COlor (page 497)/LAyer
(page 497)/Transparency (page 497)] <Properties>: Enter an option
or press Enter
Disassociate
Removes the associative quality from an associative hatch or fill.
Style
Specifies the method used to hatch or fill boundaries within the outermost
boundary.
Ignore Ignores all internal objects and hatches or fills through them.
Outer (Recommended) Hatches or fills inward from the outer boundary.
HATCH turns hatching or filling off if it encounters an internal island. This
option hatches or fills only the outermost level of the structure and leaves the
internal structure blank.
Normal Hatches or fills inward from the outer boundary. If HATCH encounters
an internal island, it turns off hatching or filling until it encounters another
island within the island.
Properties
Specifies new hatch properties for the selected hatch or hatches. You can
specify a new pattern or pattern type and then enter the pertinent properties.
For an explanation of setting pattern and fill properties at the Command
prompt, see
-HATCH (page 491).
Draw Order
Assigns a draw order to selected hatches or fills. You can place a hatch or fill
behind all other objects, in front of all other objects, behind the hatch
boundary, or in front of the hatch boundary. (
HPDRAWORDER (page 1361)
system variable)
H Commands | 499