2013

Associativity
Specifies that the new hatch pattern is updated when its boundaries are
modified.
A new hatch pattern's associativity is set by the
HPASSOC (page 1358) system
variable. Changing the associativity setting here also changes the setting in
the HPASSOC system variable.
Gap Tolerance
Sets the maximum size of gaps that can be ignored when objects are used as
a hatch boundary. The default value, 0, specifies that the objects must enclose
the area with no gaps.
Any gaps equal to or smaller than the value you specify in the gap tolerance
are ignored, and the boundary is treated as closed.
Separate Hatches
Controls whether the command creates a single hatch object or multiple hatch
objects when several separate closed boundaries are specified.
Draw Order
Assigns the draw order to a hatch or fill. You can place a hatch or fill behind
all other objects, in front of all other objects, behind the hatch boundary, or
in front of the hatch boundary.
Origin
Controls the starting location of hatch pattern generation. Some hatches,
such as brick patterns, are meant to be aligned with a point on the hatch
boundary. By default, all hatch origins correspond to the current UCS origin.
Use Current Origin Sets the value of the
HPORIGINMODE (page 1366) system
variable. The last 5 options listed below correspond to the values 1-5.
Set New Origin Specifies the new hatch origin point directly.
Default to Boundary Extents Calculates a new origin based on the rectangular
extents of the hatch. Choices include each of the four corners of the extents
and its center. You can also store the value of the new hatch origin in the
HPORIGIN (page 1365) system variable.
496 | Chapter 2 Commands