2013

-HATCH
Uses command prompts to fill an enclosed area or selected objects with a
hatch pattern, solid fill, or gradient fill.
List of Prompts
The following prompts are displayed.
Specify internal point (page 491) or [Properties (page
491)/
Select objects (page 492)/draW boundary (page 493)/remove
Boundaries
(page 493)/Advanced (page 493)/DRaw order (page
496)/
Origin (page 496)/ANnotative (page 497)/hatch COlor (page
497)/
LAyer (page 497)/Transparency (page 497)]: Specify a point or
enter an option
Internal Point
Determines a boundary from existing objects that form an enclosed area
around the specified point.
Pick Internal Point While specifying internal points, you can right-click in
the drawing area at any time to display a shortcut menu that contains several
options.
If you turn on Island Detection, objects that enclose areas within the outermost
boundary are detected as islands. How HATCH detects objects using this option
depends on which island detection method is specified.
NOTE Red circles are displayed at unconnected endpoints of boundary objects to
identify gaps in the hatch boundary. These circles are temporary and can be
removed with
REDRAW (page 881) or REGEN (page 889).
Properties
Specifies new hatch pattern properties to apply.
H Commands | 491