2013

Enter number of latitudinal segments for surface of sphere <16>: Enter a value
greater than 1 or press Enter
Diameter Defines the sphere by its diameter.
Specify diameter of sphere: Specify a distance
Enter number of longitudinal segments for surface of sphere <16>: Enter a
value greater than 1 or press Enter
Enter number of latitudinal segments for surface of sphere <16>: Enter a value
greater than 1 or press Enter
Torus
Creates a toroidal polygon mesh that is parallel to the XY plane of the current
UCS.
Specify center point of torus: Specify a point (1)
Specify radius of torus or [Diameter]: Specify a distance or enter d
The radius of the torus is measured from its center point to its outside edge,
not to the center of the tube.
Radius of Torus
Radius Defines the torus by its radius.
16 | Chapter 2 Commands