2013

See also:
Create a Flattened View
FREESPOT
Creates free spotlight which is similar to a spotlight without a specified target.
List of Options
The following options are displayed.
Specify source location <0,0,0>: Enter coordinate values or use the
pointing device
If the LIGHTINGUNITS system variable is set to 0, the following prompt is
displayed:
Enter an option to change [Name (page 448)/Intensity (page
448)/
Status (page 449)/Hotspot (page 449)/Falloff (page
449)/
shadoW (page 450)/Attenuation (page 450)/Color (page
451)/eXit] <eXit>:
If the LIGHTINGUNITS system variable is set to 1 or 2, the following prompt
is displayed:
Enter an option to change [
Name (page 448)/Intensity factor
(page 448)/Photometry (page 449)/Status (page 449)/Hotspot (page
449)/
Falloff (page 449)/shadoW (page 450)/filterColor (page
451)/eXit] <eXit>:
NOTE When the LIGHTINGUNITS system variable is set to 1 or 2, the Attenuation
option has no affect on the creation of the light. It is only maintained for scripting
compatibility.
Name
Specifies the name of the light. You can use uppercase and lowercase letters,
numbers, spaces, hyphens (-), and underscores (_) in the name. The maximum
length is 256 characters.
Intensity/Intensity Factor
Sets the intensity or brightness of the light. The range is 0.00 to the maximum
value that is supported by your system.
448 | Chapter 2 Commands