2013

Enter number of segments for surface of cone <16>: Enter a value greater than
1 or press Enter
Diameter for Top Defines the top of the cone by its diameter. A value of 0
produces a cone. A value greater than 0 produces a truncated cone.
Specify diameter for top of cone <0>: Specify a distance
Specify height of cone: Specify a distance
Enter number of segments for surface of cone <16>: Enter a value greater than
1 or press Enter
Dish
Creates the lower half of a spherical polygon mesh.
Specify center point of dish: Specify a point (1)
Specify radius of dish or [Diameter]: Specify a distance or enter d
Radius Defines the dish by its radius.
Enter number of longitudinal segments for surface of dish <16>: Enter a value
greater than 1 or press Enter
Enter number of latitudinal segments for surface of dish <8>: Enter a value
greater than 1 or press Enter
Diameter Defines the dish by its diameter.
Specify diameter of dish: Specify a distance
Enter number of longitudinal segments for surface of dish <16>: Enter a value
greater than 1 or press Enter
Enter number of latitudinal segments for surface of dish <8>: Enter a value
greater than 1 or press Enter
Dome
Creates the upper half of a spherical polygon mesh.
Specify center point of dome: Specify a point (1)
Specify radius of dome or [Diameter]: Specify a distance or enter d
Radius Defines the dome by its radius.
12 | Chapter 2 Commands