2013

Edge
Selects a single edge. You can continue to select single edges until you press
Enter.
If you select three or more edges that converge at a vertex to form the corner
of a box, FILLET computes a vertex blend that is part of a sphere if the three
incident fillets have the same radii.
Chain
Changes from selection of single edges to selection of sequential tangent edges,
called a chain selection.
Edge Chain Selects a tangential sequence of edges when you select a single
edge. For example, if you select an edge on the top of a 3D solid box, FILLET
also selects the other tangential edges on the top.
Edge Switches to a single-edge selection mode.
Loop
Specifies a loop of edges on the face of a solid. For any edge, there are two
possible loops. After selecting a loop edge, you are prompted to Accept the
current selection, or choose the Next loop.
Radius
Defines the radius of the rounded edge.
Undo
Reverses the previous action in the command.
Polyline
Inserts fillet arcs at each vertex of a 2D polyline where two line segments meet.
F Commands | 439