2013

Table Of Contents

Summary

Select four adjoining edges that define the mesh. The edges can be lines, arcs,

splines, or open polylines. The edges must touch at their endpoints to form

a single, closed loop.

You can select the four edges in any order. The first edge (SURFTAB1 (page

1500)) determines the M direction of the generated mesh, which extends from

the endpoint closest to the selection point to the other end. The two edges

that touch the first edge form the N edges (

SURFTAB2 (page 1500)) of the mesh.

The MESHTYPE (page 1408) system variable sets which type of mesh is created.

Mesh objects are created by default. Set the variable to 0 to create legacy

polyface or polygon mesh.

List of Prompts

The following prompts are displayed.

Object 1 for surface edge Specifies the first edge to be used as a boundary.

Object 2 for surface edge Specifies the second edge to be used as a boundary.

Object 3 for surface edge Specifies the third edge to be used as a boundary.

Object 4 for surface edge Specifies the final edge to be used as a boundary.