2013

Table Of Contents
Toggle (Angle From) Toggle (Angle From) (page 391)
Distance
Moves the camera in or out along the line of sight relative to the target. This
option turns on perspective viewing, which causes objects farther from the
camera to appear smaller than those closer to the camera. A special perspective
icon replaces the coordinate system icon. You are prompted for the new
camera-to-target distance.
A slider bar along the top of the drawing area is labeled from 0x to 16x, with
1x representing the current distance. Moving the slider bar to the right
increases the distance between camera and target. Moving it to the left
decreases that distance. To turn off perspective viewing, click the Off option
from the main DVIEW prompt.
If the target and camera points are close together, or if you specify a
long-focal-length lens, you might see very little of your drawing when you
specify a new distance. If you see little or none of your drawing, try the
maximum scale value (16x) or enter a large distance. To magnify the drawing
without turning perspective viewing on, use the Zoom option of DVIEW.
392 | Chapter 2 Commands